Ethernet-DMX2 MkII

Ethernet-DMX2 Rack (Wyg enabled)

The Ethernet-DMX2 MkII is an Ethernet node that serves two DMX512 outlets, conform to DMX512-A, that can be used as input or output. The Ethernet link on the front is a 10/100BaseTX connection on a Neutrik RJ45 Ethercon connector. All configuration can be done over Ethernet through a build in Web site. This all comes in a 19" 1 unit high metal housing that can be rack mounted.


  • 1 x 10/100BaseTX Ethernet ports on Neutrik RJ45 Ethercon connector
  • 2 x DMX512-A in/outputs on shielded, isolated and gold plated Neutrik 5 pin female XLR, with termination
  • 1 x IEC inlet with fuse holder


  • DMX routing, universe setting
  • Input and output enable / disable
  • DMX output frame rate setting
  • Supported protocols: DMX, DMX512-A, RDM, Art-Net™, sACN
  • Protocol selection per port
  • IP settings
  • Unit ID and labeling
  • Ethernet activity indication on front panel
  • Up to 40 programmable profiles and routings
  • Up to 10 predefined profiles (splitters, mergers...)
  • Multi language Web interface


  • Ethernet <-> DMX conversion
  • Ethernet and DMX Merger
  • Ethernet and DMX Backup
  • DMX splitter / booster
  • DMX trigger. Remote selection of the control source
  • Built-in DMX softpatch
  • Wysiwyg enabled. DMX inputs can be visualised in Wysiwyg
  • DMX snapshot. Capture 3 fixed lighting states per outlet
  • Modification of captured values from the Web interface
  • Auto-load capture on boot-up (ideal for expo)